Driving shaft and its support
Put the driving shaft to the shaft support, and connect the 2 neighbouring StyleAPinions with the driving shaft. When the 2 neighbouring pinions' center line is parallel with the driving shaft line position, fix the shaft support to the pole of the structure.
All the shaft supports are installed in the same way as mentioned above. All the drivingshafts should be on the same parallel position. Disconnect the shaft from the place where the motor is positioned, for preparation of the motor installation.
Item | Name | Specification | Application |
1 | Shading Motor | GW10,GW30,GW40,GW80 | torque 100-800Nm;rotate speed 2.6-5.2rpm |
2 | shaft joint | 1",5/4" | 1",5/4"driving shaft |
3 | Pinion | Style A,transmission ratio 1:1.8 | 1",5/4" driving shaft |
4 | Rack | L=3160,3965 mm | Greenhouse section 3-5m |
5 | Welding joint | 1",5/4" | 1",5/4" driving shaft |
6 | Coupling connector for rack | dia. 27,dia 32 |
Characrisitc
High Duration time
Nice Coating
OEM service offered
gear rack and pinion
Specification
greenhouse rack and pinion for ventilation
Material:Galvanized steel
Length :1050mm/1250mm/OEM
Galvanization :275g
Thickness:2-3mm
Application: greenhouse ventilation system
| Name | Voltage | frequency | Speed | Power | Range of speed | Allowable torque |
| Greenhouse gear motor for vent open and close | 380V | 50HZ | 2.6rpm | 0.55KW | 5.2 rpm | 400N.m |
| 0.75KW | 800N.m
|
![Hot Selling Greenhouse Rack and Pinion for Ventilation]()
![Hot Selling Greenhouse Rack and Pinion for Ventilation]()
English
